gouging torch spares

Shields connection between the cable and the brass body. Compressed-air control valve fits through its centre.

Upper & lower insulators to prevent live jaw contact.

Upper & lower insulators to prevent live jaw contact.

Our K3, K4000 and K5 type gouging torches terminate in a US threaded fitting, for connection to the compressed air supply. This adaptor converts this US thread to a standard UK 3/8" BSP RH fitting.

Operate as a valve for ‘on/off’ control of the compressed air. Bonnet is held in place by the spool.

The lower jaw of the torch. Holds the Head Assembly and connects to the monocable.

Connect to the pivot of the brass body part to complete the upper jaw and hold the carbon in place.

Shields connection between the cable and the brass body. Compressed-air control valve fits through its centre.

Also known as ‘Injector’ nozzle. Fits the brass body. Holds carbon in place and carries current. The injection nozzle ELC232205 for the Flair Torch Assembly has 2 holes.

Also known as ‘Injector’ nozzle. Fits the brass body. Holds carbon in place and carries current.

Upper & lower insulators to prevent live jaw contact.

The Push Button is a replacement part for the Flair 2 torch. You can identify where this part is used by cross reference to the parts manual below. The flair 2 type gouging torch is a 600 amp carbon-arc torch ideal for use in fabrication and boiler shops shipyards maintenance shops and foundries for applications up to 600amps. It will accept round type arc welding carbons from 4mm to 10mm diameter.

The Screw is a replacement part for the Flair 2 torch. You can identify where this part is used by cross reference to the parts manual below. The flair 2 type gouging torch is a 600 amp carbon-arc torch ideal for use in fabrication and boiler shops shipyards maintenance shops and foundries for applications up to 600amps. It will accept round type arc welding carbons from 4mm to 10mm diameter.

Part of the lever assembly that controls the opening and closing motion of the upper arm jaw in a carbonarc gouging torch.

The lower jaw of the torch. Holds the Head Assembly and connects to the monocable.

Operate as a valve for ‘on/off’ control of the compressed air. Bonnet is held in place by the spool.

Operate as a valve for ‘on/off’ control of the compressed air. Bonnet is held in place by the spool.

Shields connection between the cable and the brass body. Compressed-air control valve fits through its centre.

Also known as ‘Injector’ nozzle. Fits the brass body. Holds carbon in place and carries current.

Upper & lower insulators to prevent live jaw contact.

Help to raise and lower the upper arm jaw and to insulate live parts against contact. Sold each.

Upper & lower insulators to prevent live jaw contact.

Also known as ‘Injector’ nozzle. Fits the brass body. Holds carbon in place and carries current.

Part of the lever assembly that controls the opening and closing motion of the upper arm jaw in a carbonarc gouging torch.

Connect to the pivot of the brass body part to complete the upper jaw and hold the carbon in place.

The lower jaw of the torch. Holds the Head Assembly and connects to the monocable.

Help to raise and lower the upper arm jaw and to insulate live parts against contact. Sold each.

The Screw for Lever is a replacement part for the Flair 2 torch. You can identify where this part is used by cross reference to the parts manual below. The flair 2 type gouging torch is a 600 amp carbon-arc torch ideal for use in fabrication and boiler shops shipyards maintenance shops and foundries for applications up to 600amps. It will accept round type arc welding carbons from 4mm to 10mm diameter.